LG WD(M)-14400(5)TB Service Manual page 30

ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
■ ■ Clean the drain pump filter
1. Open the lower cover cap ( )by
using a coin. Turn the drain plug
( )to pull out the hose.
Remove the back cover.
Take off the belt turning the pulley.
Unscrew the bolt to pull out the pulley.
Unscrew 2 screws from the bracket.
Push the motor in the arrow direction for disassembling
and take out it at the front of the Washing Machine.
When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again
It may be taken off during operation.
2. Unplug the drain plug ( ),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor.
When water does not flow any
more, turn the pump filter
( )open to the left.
29
3. Remove any foreign material from
the pump filter ( ). After
cleaning, turn the pump filter ( )
clockwise and insert the drain
plug ( )to the original place.
close the lower cover cap.