Laars newport Installation, Operation And Maintanance
Laars newport Installation, Operation And Maintanance

Laars newport Installation, Operation And Maintanance

Oil fired

Advertisement

Installation, Operation and Maintenance Instructions
Installation,
Operation and
Maintenance
Instructions for
Newport
Oil Fired Boiler
FOR YOUR SAFETY: This product must be installed and serviced by a professional service technician,
qualified in boiler installation and maintenance. Improper installation and/or operation could create
carbon monoxide gas in flue gases which could cause serious injury, property damage, or death.
Improper installation and/or operation will void the warranty.
If the information in this manual is not followed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
Installation and service must be performed by a qualified installer, service agency, or fuel oil supplier.
WARNING
®
Heating Systems Company
BRADFORD WHITE
®
A subsidiary of
Corporation
Document 1100C

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the newport and is the answer not in the manual?

Questions and answers

Summary of Contents for Laars newport

  • Page 1 Installation, Operation and Maintenance Instructions for Newport Oil Fired Boiler FOR YOUR SAFETY: This product must be installed and serviced by a professional service technician, qualified in boiler installation and maintenance. Improper installation and/or operation could create carbon monoxide gas in flue gases which could cause serious injury, property damage, or death.
  • Page 2: Table Of Contents

    LAARS Heating Systems Page 2 TABLE OF CONTENTS SECTION 1. 1.14 Electrical Wiring..........4 1.15 Operation General Information (Honeywell L.8124A or L7224A aquastat Boiler Installation ...........3 relay)............4 Freight Claims ..........3 1.16 Domestic Water Piping ........4 Boiler Location..........3 1.17 Cleaning the Boiler ........5 Boiler Clearances (to combustibles)....
  • Page 3: General Information

    ASME codes using heavy CAUTION gauge steel tubes and boiler plate. Newport boilers must not be directly connected The reliable heat exchanger incorporates special to a heating system using oxygen permeable flue baffles to assure quiet and efficient operation and tubing (see warranty).
  • Page 4: Jacket (Normally Fi Tted)

    LAARS Heating Systems Page 4 Fuel Line: A single pipe system of not less 1.8 Jacket (normally fitted) than 3/8" OD copper tubing is recommended when If not fitted, assemble panels in accordance with fuel storage level is not below the fuel unit. A two in struc tions in Figure 4.
  • Page 5: Cleaning The Boiler

    Newport Oil-Fired Heater Page 5 It is recommended that a service contract be WARNING ar ranged with a properly equipped serviceman who Flue gases are dangerous - do not operate will be able to do the job efficiently and without mess.
  • Page 6: Cleaning The Chimney

    LAARS Heating Systems Page 6 1.20 Maintenance of the Tankless Coil Remove soot and scale deposits from tubes with After several years of use, the water flow through a flexible wire brush, taking care not to damage the coil may become restricted by mineral deposits “ceraform”...
  • Page 7 Newport Oil-Fired Heater Page 7 Dimensions and Specifi cations NP 85 - 110 NP 125 - 150 inches inches Jacket Height 35½ Jacket Width 19¼ 20½ Jacket Length 21½ Return Tapping Height 19½ Supply Tapping 33½ Coil Supply Height 27½...
  • Page 8 LAARS Heating Systems Page 8 Instructions 1. Pre-assemble L/H side (1) and R/H side (2) to front panel (3) with screws. 2. Slide assembled jacket over boiler and secure side panels to base tray. 3. Fix rear panel (4) to sides.
  • Page 9 Newport Oil-Fired Heater Page 9 Air vent 1¼" min. Fill pipe One-Pipe System Oil tank Valve "P" Burner Boiler Filter "H" Figure 5A Air vent 1¼" min. Two-Pipe Burner System Filter Boiler Fill pipe Valve "H" tank Figure 5B PIPE LENGTHS...
  • Page 10 LAARS Heating Systems Page 10 Power supply provides disconnect means & overload protection as required. Room Thermostat L1 (Hot) Power Supply 120V Circulator Switch Low Limit Circulator Hi Limit Oil Burner Relay Heating Circulator AQUASTAT RELAY L8124A WIRING ARRANGEMENT FOR “NP” BOILER CONTROLLING OPERATION OF BOILER AND CIRCULATOR Figure 6.
  • Page 11: Replacement Parts

    Replacement Parts 2.1 Ordering Information To order or purchase parts for Laars products, contact your nearest Laars dealer of distributor. If they cannot supply you with what you need, contact Laars Customer Service at the address shown on the back cover of this manual.
  • Page 12 20 Industrial Way, Rochester, NH 03867 • 603.335.6300 • Fax 603.335.3355 Heating Systems Company 1869 Sismet Road, Mississauga, Ontario, Canada L4W 1W8 • 905.238.0100 • Fax 905.366.0130 BRADFORD WHITE ® A subsidiary of Corporation www.Laars.com Litho in U.S.A. © Laars Heating Systems 0805 Document 1100C...

Table of Contents