Reset Functions - Philips HDP2510 User Manual

Front Ceiling – the device is hanging from
the ceiling in an upside-down position; the
image is rotated by 180 degrees.
Rear ceiling – the device is located behind
the projection surface, hanging from the ceil-
ing in an upside-down position; the image is
rotated by 180 degrees and reflected hori-
zontally.

Sleep mode
Adjusts the time until the projector should go
into sleep mode and powers off after ten
seconds if user doesn't stop it. The following
options are available: Off, 30 min., 45 min.,
60 min., 120 min.

Screen saver
Adjusts the time until the system should
power down the lamp if no source is con-
nected to system. The followings options are
available: Off, 1 min., 2 min., 5 min., 10 min.,
30 min.
Auto power down (APD)
Switches the auto power down On and Off.
Notice
The default setting is depending on the
choice of Shop mode or Home mode
(see Initial installation, page 14).
When the function is switched on, the pro-
jector should go into off mode after three
hours.
If a video is displayed, the APD should take
place three hours after last user action,
meaning that a pop-up will appear after
2:58 hours for two minutes, indicating that
the device will go into off mode.

Reset lamp timer
Resets the lamp timer of the system.
CAUTION!
Do not reset the lamp timer if the lamp
has not been replaced as this could
cause damage (see Resetting the lamp
timer, page 30).
Language/language
Selects the desired language.

Shop Mode
Switches the shop mode On and Off.
In this mode, the Screeneo logo is continu-
ously displayed on the screen and system
powers on after power is available. System is
Settings


set to shop mode conditions and settings are
set back to default settings after a certain
period of time.

Firmware update
Updates firmware (see Update firmware
with USB storage medium, page 19).
Information
Information
Source
Source
Smart settings
Image
3D settings
3D
Equivalent lamp hour
Resolution
Sound
Firmware version
System
Engine version
Information MCU version
OK
Model

Information
Displays an overview of the status and ver-
sion of the device.

Reset functions

You can select between two different reset
functions:
Reset image settings
This function resets the current chosen Smart
settings back to default mode.
Image settings
Source
Smart settings
Format
Image
Brightness
3D
Contrast
Saturation
Sound
Sharpness
System
Lamp power mode
Information Flow motion
Wall colour correction
Advanced colour settings
Reset current image settings
1 Press the OPTION/Ă button and use ¡/¢
to select Image.
2 Confirm with OK.
3 Use ¡/¢ to select Smart settings.
4 In the status bar appears Reset current
image settings.
5 Use À/Á to select Standard*.
6 Confirm with the RED key.
HDMI1
Standard
2D
0 h
1920 x 1080
V1.0
V1.111
V1.11111
HDP2510
Standard
Original
50
50
50
16
Standard
On
OFF
27