BMW K1200 R Rider's Manual page 114

• The procedure for changing
6
the high-beam headlight
bulb is the same as that for
112
the low-beam bulb. Note,
however, that the high-beam
headlight bulb is held in
place by a single-leg, vertical
spring clip.
Replacing parking light
If it is not standing firmly,
the motorcycle could
topple in the course of the
operations described below.
Make sure that the motorcycle
is steady on its stand.c
• Switch off the ignition.
• Remove securing screws 1
on both sides of the bulb
housing.
• Pull the bulb housing for-
ward and tilt it slightly down.
• Turn bulb holder 2 counter-
clockwise to remove it from
the headlight housing.
• Remove bulb 3 from the bulb
holder.
Installation is the reverse of the
removal procedure.
• Use a clean, dry cloth to hold
the new bulb.