BMW K1200 R Rider's Manual page 107

• Roll the rear wheel onto the
rear wheel support.
• Place the rear wheel on the
rear wheel support.
• If the BMW Motorrad rear
wheel stand is used: attach
the retaining disc again.
• Install studs 5 and tighten in
diagonally opposite
sequence to 60 Nm.
• Turn the end silencer to its
initial position.
• Install screw 4 for the
bracket of the end silencer in
the rear footrest, but do not
tighten it at this point.
• Align clamp 3 on the end
silencer with mark A (arrow)
on the oxygen sensor B.
• Tighten clamp 3 on the end
silencer to 35 Nm.
6
105