Refrigerator Door - Amana DB11 Installation Instructions Manual

Refrigerator Door

Important
• Permanent, double-sided tape is used to attach trim
pieces. Before removing paper backing, check
placement of trim pieces on door. Trim pieces may
be damaged if adjustment or removal is attempted
after installation.
15. Install door stop and refrigerator door bottom trim
using center holes for alignment. For right hinge
application use outside holes, for left hinge
application use inside holes to attach bottom trim.
Refrigerator door bottom trim will have 4 oblong holes
and 4 round holes. DB11S kit comes with a silver
door stop for the refrigerator door.
A
E
A —Left hinge application
B —Screws
C —Door stop
D —Right hinge application
E —Door stop
16. Install top hinge bracket on top of refrigerator by
installing rear screws loosely with a 8 mm hex nut
driver. Position refrigerator door on door closure.
Install remaining screw and tighten all screws. Verify
handle side of door is approximately 3 mm higher
than the hinge side. Door lowers when loaded with
food and when panel is installed.
C
B
17. Align refrigerator door top and handle side trim on
door. After verifying placement, peel off paper backing
and press trim in place. Refrigerator door top trim will
have no holes in it. Refrigerator door handle side trim
will be cupped on both ends.
A
D
A —Handle side (end of trim both ends)
B —Hinge side (end of trim both ends)
18. Replace top hinge cover by snapping on top hinge.
19. Install refrigerator door decorator panel by sliding
panel in from hinge side of refrigerator door.
20. Align hinge side door trim. After verifying placement,
peel off paper backing and press trim in place.
Refrigerator door hinge side trim is cupped on both
ends but has a small notch on each end in cup
section. (See above drawing)
21. Open door 180° then close door to confirm panel and
trim fit properly.
4
B