Table of Contents
Advertisement
dCS Vivaldi Upsampler User Manual
We have tested this interface with several common formats running on Windows™ 8.1,
!
Windows™ 7, Windows™ Vista (SP2), Windows™ XP (SP3) and Apple Mac™ OSX
10.5 - 10.10 with various PCM streaming programs but we cannot accept responsibility
for correct operation with all source devices, operating systems or software.
The
Settings > USB Class
without a special driver) or
onwards, the dCS USB Class 2 driver is required for Windows).
Operation at 352.8 or 384kS/s on Windows PCs requires the 2014 version of the dCS
USB Class 2 Driver. If you have updated your Upsampler software from v1.0x, un-install
any earlier version of the Driver from your Windows PC, download the updated Driver
from
http://www.dcsltd.co.uk/products/vivaldi-upsampler/
USB2
The
interface (W) on an 'A' type connector can stream PCM music files in most popular formats
at up to 24 bits / 192kS/s from a USB Flash Drive. With a Flash Drive connected, a basic browser (see
page 17) navigates to the music files and selects the file to be played. After closing the browser, the
name of the file is displayed, with a Play or Pause icon and the elapsed playing time.
Mains-powered USB hard disk drives in FAT16 or FAT32 format may be used in the same way. The
interface will not read drives in NTFS format or other formats.
USB2
The
interface will also accept PCM music files up to 24 bits at 44.1 or 48kS/s streamed from an
iPod or iPhone. Note that metadata is not displayed.
Test
interface
Test
The
interface (X) is an RS232 interface with two modes, set by the
• Binary mode is used to remotely control the unit during automated production testing at dCS.
• Text mode is for use with a household automation system. If you would like to use this mode,
please download the list of remote control commands from www.dcsltd.co.uk.
The interface is designed to be used with a "straight through" cable, wired pin 1 to pin 1, etc.
The pin connections are:
• Pin 2 – dCS unit transmit
• Pin 3 – dCS unit receive
• Pin 5 – ground
• Shell – cable screen & drain wire
Mains inlet
Power is connected via a standard IEC320 connector (Y), protected by a fuse and isolated by a 2-pole
power switch.
Label
The label (Z) states the unit's serial number and the nominal voltage to which the unit is set. It is
important to quote the serial number if you need assistance.
Vivaldi Upsampler Manual v1_2x
menu page can set the interface to
Class 2
(up to 384kS/s, no driver is required for OSX 10.6.3
Page 28
Software Issue 1.2x
December 2015
Class 1
(up to 96kS/s
and install it.
Settings > RS232
menu page.
English version
Advertisement
Table of Contents
