Table of Contents
Advertisement
dCS Vivaldi Upsampler User Manual
Single wire PCM
Connect one or more of the PCM outputs
matching inputs on your DAC. Use the
to 32, 44.1, 48, 88.2, 96, 176.4 or 192kS/s or DSD.
If you want to use the
scroll to the
sequence is
Use the DAC's
!
If the output sample rate is
The Upsampler will not output sample rates that are lower than the input sample rate.
Analogue
outputs
to Amplifier
Connect the DAC's outputs to the amplifier & speakers. Start the source playing and set the DAC's
Volume control to a comfortable level. You should have audio at this point.
Go to STEP 3.
Vivaldi Upsampler Manual v1_2x
Output
AES1
Settings > Dual AES
Menu, ►, Menu,
Input
button to select that input.
Figure 2 – Connecting a single-wire SPDIF output
Out,
AES2
(AES1
button on the front panel to set the output sample rate
AES2
and
outputs in single-wire mode, open the menu,
page and make sure it is set to Off. (The button
►.) If it is not, press the
352.8
or 384, the two SPDIF outputs will be muted.
Page 11
Software Issue 1.2x
December 2015
Out,
SPDIF1
Out,
SPDIF2
Menu
button once.
Out) to
English version
Advertisement
Table of Contents
