Table of Contents
Advertisement
Middle Setting
Symbol: Circle half filled in
Symbol: Circle filled in
By means of the rocker switch with the face symbol (6), the U-P-P Lamps or the face tanners (depending on
the type of unit) are switched on to supplement the long fluorescent lamps.
2.4
Cleaning the Acrylic Sheet: Use Approved Cleaner only !
Always ensure strict hygiene
After every use, the acrylic tanning surfaces must be disinfected and cleaned. Use cleaning materials in
accordance with the manufacture's instructions. DO NOT pour or spill liquid over unit.
After every tanning session, clean the acrylic sheet with PC Marketing's acrylic cleaner. When using the
cleaner, spray it on the acrylic sheet, let sit as directed on label. Always dry it off with a clean cloth.
3
INSTALLING THE UNIT
To install the unit, at least two persons are needed. The room in which the unit is to be
installed must be well ventilated. There is a risk of overheating if proper air conditioning
and exhaust is not installed in the tanning room.
3.1 Installation Site and Delivery Condition
All units are intended only for tanning in the interior of buildings. Operate the unit in areas where there is no
risk of hazard and only in dry rooms. The rooms must be well ventilated.
3.2 Installation and Assembly
Dismantling the canopy (figure 1)
Remove packing and the Superfan . Remove the front cover (18) (figure 2) by grasping it on the two thin
sides and then pulling forward. The Velcro strips come undone.
Remove the cover plate (19) by undoing screws (20). aise the canopy and remove the headrest (84). Take
off the upper cover (8) by sliding the cover from the rear of the unit towards the middle until the cover slides
out of the rear rail. Then take it out of the large cover (53). Take off the cover (9) by removing the caps(10),
screws (11) and inserts (12). Disassemble the cover (13) and the cover plate 941) the same way. lways
unscrew the two hexagon head bolts (15) with washers (16) from the two holders (14) on the rear side of the
canopy and put them aside for later assembly.
DO NOT remove the upper pan head screw (17). By means of this screw the canopy is
suspended in the holders of the lift (14).
Check that all connectors in the right hand cavity of the pedestal (30) are undone. Take the canopy off by
pulling the pan head screws (17) over the holders (14).
Do not dissemble the two long grey cable (43) from the canopy, they should remain
attached.
• Dismantling the Lounge, Pedestal and Lift (figure 2)
Pull the drawer (21), the canopy drawer (22) and the controls drawer (23) out of the guide rails.
Important! The GB Model has only two drawers.
Undo the nuts (24) and washers from the centring pins (49) which secure the lounge. With an assistant lift
the lounge and place it on a suitable surface. Be careful with the connecting cables (42). Remove the 4
hexagon head bolts (25) and washers (26) from the inside of the pedestal. Keep these parts in a safe
place for later assembly. Remove the two rear trim pieces (27 & 28) which are fixed with strips of Velcro.
Disassemble the side trim panels (31,33) by removing the screws. On trim panel (32) only slacken the two
screws (88) and remove the other two screws (89) completely. The cover can then be pulled off to the
front. Carry all the parts wher you install the unit.
- Inflow of cooling air OFF
- Half inflow of cooling air
- Maximum inflow of cooling air
7
Hide quick links:
Advertisement
Table of Contents
