Maintenance Of The Face Tanners (Gb Version) - PC MARKETING Tropical Series Care, Use And Installation Instructions

RELAMPING INSTRUCTIONS
REPLACEMENT LAMP TYPES
CAUTION: REPLACE ONLY WITH ORIGINAL LAMPS OR FDA APPROVED EQUIVALENT
15 Min. Timer
41 U·P·P
CANOPY: COSMEDICO - COSMOLUX VLR FR71
100W BI-PIN (PART NO: 18810)
COSMEDICO - SHORT LAMPS
LS 25W BI-PIN (PART NO. 10 030)
LOUNGE: COSMEDICO - COSMOLUX VLR FR71
100W BI-PIN (PART NO: 18 810)
32 GB
CANOPY: COSMEDICO - COSMOLUX VLR FR59
80 W BI-PIN (PART NO: 18 790)
HEREAUS NOBLELIGHT - 400W
Q460Z4 (PART NO. 44 005)
LOUNGE: COSMEDICO - COSMOLUX VLR FR71
100W BI-PIN (PART NO: 18 810)
6.2 Maintenance of the Face Tanners - (GB Version)
The High Pressure face tanner can only be used with the two glass filter plates in place; if
these are damaged or missing, tanning MUST NOT take place ! There is a danger of burns
! Danger of eye injury cause by excessive intensity!
When the face tanner has been running and is switched off and on again immediately, it may not light up
again, and will not provide full power, since it requires a cooling down phase of about (4) minutes. The low
pressure lamps require no cool down period for restarting.
• • • • • Changing the High Pressure Lamp (figure 4)
Remove the acrylic sheet in accordance with the previous description. Remove the cheese-head screw
(62) on the glass filter plate holder (63). Tilt the glass filter plate holder down. Hold the filter plate holder
with both hands, and push it towards the end cover so that it becomes detached. Grasp the high pressure
lamp (64) by the rectangular end of the lamp, and pushing it in the lengthsways into the holder (65) until it
is released at the other end. Now pull it out in a downward direction.
You must NEVER pull on the glass of the lamp.
Hold the new high pressure lamp by the end of the lamp only. Plug the lamp (64) into the holder (65). Push
the holder back. Insert the new lamp.
You must NEVER touch the glass of the high pressure lamp with your fingers.
If you have touched it by accident, wipe off your fingerprints by means of a clean cloth moistened with
alcohol.
To obtain replacement tanning lamps for the high pressure facial tanners, please
contact PC Marketing. No liability can be accepted if replacements other then genuine
lamps, and starters are installed.
• Cleaning the reflectors
Before you insert the new lamps, wipe the reflectors by means of a cloth moistened with alcohol.
• Cleaning the glass filter plates
Unscrew the two cheese-head screws (66) on the filter plate holder (63). Take off the cover plate (67). Pull
out the dark glass filter plate (91) and the clear glass filter plate (69). Clean both glass filter plates with
warm water to which some detergent can be added. Wipe the glass filter plates dry with a clean cloth.
20 Min. Timer
COSMEDICO - COSMOLUX
SP 25 short lamp (10039)
WOLF SYSTEMS – ETERNAL SUN
F 71 100 W BI PIN (21 182)
WOLF SYSTEMS – ETERNAL SUN
F 71 100 W BI PIN (21 182)
WOLF SYSTEMS – ETERNAL SUN
F 51 80 W BI PIN (26 021)
HEREAUS NOBLELIGHT - 400W
Q460Z4 (PART NO. 44 005)
WOLF SYSTEMS – ETERNAL SUN
F 71 100 W BI PIN (21 182)
12