Table of Contents
Advertisement
• One or more lamps are not lighting (change of starter)
Take off the acrylic sheet of the lounge or canopy. Check whether the lamp in inserted properly. Then check
that the starter is seated properly.
Starter - Tanning Lamp in lounge - On lamp holders at the head end; take off
Tanning Lamp in canopy - On lamp holders at the foot end; take off the
Short Lamps in canopy - Take off the covers (83 and 53)
Remove the starter for the lamp that is not lighting then turning it counter clockwise, and then put it back in
again by turning it clockwise. If the lamp still does not light, insert the starter from a working lamp. If this is
not successful, the lamp must be checked. Insert the lamp that is not lighting into a holder where a lamp
does light. If the lamp does not light, it is defective and will have to be replaced. If it does light, there is an
electrical short in the unit.
Any electrical shorts should be checked by an authorized technician approved
by PC Marketing.
• • • • • The canopy or the lounge gets too hot.
Check whether the air intake filters (filter pads) are clogged. In the case of units with direct discharge of air,
ensure that the heated cooling air is passed into the outside atmosphere without excessive resistance.
There must not be excessive hindrance of the air flow, either in the flexible duct or in the ventilation duct,
because this will case overheating of the unit.
This check should be performed by an authorized technician approved
by PC MARKETING.
figure 1
80
81
91
86
87
53
17
14
61
30
46
45
86
85
34
35
57
12
11
10
the acrylic sheet (82)
acrylic sheet (83)
8
44
16
43
15
12
11
10
(56)
(90)
17
14
13
9
12
11
10
41
55
12
11
10
14
figure 1.1
44
16
43
15
figure 1.2
1
65
70
64
63
Hide quick links:
Advertisement
Table of Contents
