Table of Contents
Advertisement
3.4 Electrical Connection
Important: The electrical connection work should only performed by a certified
electrician in accordance with local laws
Important:
In the case of connection to a fault current circuit-breaker (<,=) 30 mA, it must be noted that, during the
ignition process, discharge current peaks occur which are so short that they can only be detected with an
oscilloscope. Therefore, if serveral units are operated together to one and the same fault current circuit-
breaker, the peaks can be additive and can cause the fault current circuit-breaker to trip even although
there are no defects in the units.
3.5 Remote Timing Control
Therefore, never connect more than one unit to one and the same fault current circuit-
breaker (< =) 30 mA
• Disconnect the unit from the mains!
The unit is equipped for connection to a remote timer system for central control.
• Coding plug for connection to a remote timing system (Figure 2)
Insert the coding plug (85) with cable (86), which is situated on the right-hand end face of the pedestal, into
the special socket with retaining clip. This cable forms the connection to the token box of remote system.
The cable has four cores (phase, switched phase, neutral). Therefore, the remote control system does not
need a separate electrical connection ground.
4 PLACING INTO OPERATION
4.1 Technical Data and Dimensions*
Designation
Power (W)
Operating Voltage
Amperage
Weight
Length with InterCooler
Width
Height Canopy Open
* We reserve the right to make technical changes
4.2 Before Placing in Operation
Before installation and placing in operation, the safety instructions and operating instructions must be
carefully read and observed.
4.3 Placing the unit into operation for the first time
Before the unit is placed in operation, the local safety regulations and safety instructions must be observed.
When the unit is completely installed, electrically connected and connected to the remote timing system (if
applicable), it can be placed in operation.
Instructions to the operator:
• DO NOT place any malfunctioning units into operation.
• Disinfect the acrylic shield with a UVT (ultraviolet transmitting) acrylic cleaner
• supplied by PC MARKETING.
• Provide protective eyewear and require their use during tanning.
• Observe and follow recommended exposure schedule which lists skin type,
• exposure times and frequencies.
• Keep operating instructions available at all times.
• Display the safety instructions in a clearly visible manner in the tanning room.
Tropical Series
32 GB
4,600
220V 60 Hz Single Phase
40
685 lbs
88.5 in.
44 in.
55 in.
10
.
.
41 U
P
P-i
4,300
220V 60 Hz Single Phase
30
640 lbs
88.5 in.
44 in.
55 in.
Hide quick links:
Advertisement
Table of Contents
