Finish Function; Local Area Network (Lan) Setup - Paradyne 6212-I1 User Manual

Finish Function

After you change any item in WAN Setup, remember to click on the Finish button to
apply the changes and reboot the system.

Local Area Network (LAN) Setup

You can configure the DSL Router IP address and Subnet Mask for the LAN
interface to conform your LAN's IP Subnet. If you want the DHCP server to
automatically assign IP addresses, then enable the DHCP server and enter the
range of IP addresses that the DHCP server can assign to your computers.
Disable the DHCP server if you would like to manually assign IP addresses.
The Save button only saves the LAN configuration data. The Save/Reboot button
saves the LAN configuration data and reboots the router to make the new
configuration effective.
Figure 5-7.
6212-A2-GB23-00
LAN Setup
September 2005
5. Advanced Setup
5-5