Equipment Checklist - SMC Networks SMC2655W User Manual

Equipment Checklist

After unpacking the EZ Connect Wireless AP, check the contents of
the box to be sure you have received the following components:
· 1 EZ Connect Wireless Access Point (SMC2655W)
· 1 5 VDC power adapter
· 1 Driver, Utility, and Documentation CD-ROM
· This User Guide
Immediately inform your dealer in the event of any incorrect, missing
or damaged parts. If possible, please retain the carton and original
packing materials in case there is a need to return the product.
The EZ Connect Wireless Access Point is covered by a limited lifetime
warranty.
Complete warranty information for all SMC products is available on
SMC's Web site at www.smc.com
3
SMC2655W: Installation Instructions
1)Site Location – Choose a location for your SMC2655W Wireless
Access Point. Usually, the best location is at the center of your
wireless coverage area, if possible within line-of-sight of all
wireless devices.
2)Placement - Put the Access Point in a position that gives it
maximum coverage. Normally, the higher you place the antenna,
the better the performance.
3)Connect the Ethernet cable – The SMC2655W can be wired to an
Ethernet network through an Ethernet device such as a hub or a
switch using category 3, 4, or 5 UTP Ethernet cable and an RJ-45
connector.
4)Connect the power cable – Connect the power adapter cable to
the 5 VDC power socket on the rear panel.
Warning: Use only the power adapter supplied with the SMC2655W.
4