Mitsubishi 290p106010 Operating Manual page 6

Part IV: Operation
Programming the Remote Control to Control Non-NetCommand ™
A/V Products
Figure 4. Programming the remote to control your DVD/
LDP.
Figure 5. Programming the remote to control your A/V
receiver.
If the remote control has not been
programmed to operate NetCommand ™
and slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Afte r entering the corre ct codes in each posi-
tion of the remote control, use the slide
switch to sele ct which product will respond
when an ope rational button is pressed. If
the T V position has not been programmed
to control N etC ommand ™ and you enter a
code from the A /V R e ceiver chart while the
slide switch is set to T V, the volume and
mute functions change to match the A /V
re ceiver. T his is useful when using an A /V
re ceiver with the T V all the time. In all
other cases, only one of the below devices
is allowed for each slide switch position.
T V position (when the remote has not been
programmed to operate N etC ommand ™ ) :
T V
A /V re ceive r (volum e and m ute only)
C able /D BS /DT V position:
C able box
S atellite re ceive r
D T V re ceive r
VC R position:
VC R D V D
D V D position:
D V D
C able box
Audio position:
A /V re ceive r
M itsubishi C D playe r
re ce ive r, the a udio position m ay be use d in conjunction w ith
se le cte d M itsubishi C D playe rs. Your a udio position m ust be
progra m m e d to 010 ].
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
LD P laye r
LD P laye r
VC R
C able box
[If you have a M itsubishi A / V