Mitsubishi 290p106010 Operating Manual page 5

Programming the Remote Control to Control Non-NetCommand ™
A/V Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(F igure s 1-5 )
1
M ove the slide switch at the top of
the rem ote to the product you want to
control.
2
P ress and hold the P O W ER button on
the rem ote control.
3
Ente r the rst th r ee di g i t co de li s t ed for
your e quipment, and then release the
P O W ER button on the rem ote control.
P oint the rem ote control at the e quip-
ment and press the P O W ER button.
If the e quipment responds, the rem ote
control is prope rly programme d to ope r-
ate the e quipment. If the e quipment
does not respond, repeat steps 2-4 with
the next three digit code liste d in step 3
for your e quipment.
Figure 1. Programming the remote to control your cable
box.
If you cannot turn the cable box ON
by pressing POWER, try pressing CHAN-
NEL or the number buttons.
Figure 2. Programming the remote to control your satel-
lite receiver.
Figure 3. Programming the remote to control your VCR.
When the switch is set to TV, the PLAY,
STOP, REW/REV, and FF/FWD buttons
will operate the VCR after the VCR codes
have been properly programmed into
the remote control.
Part IV: Operation