Paradyne COMSPHERE 3821PLUS User Manual page 55

SDCP Menus
Table 3-5
(5 of 5)
DTE Dialer Configuration Options
V25bis IdleFill: Mark
Nxt Mark Flag
V.25bis Idle Fill. Determines whether a mark or flag is used as an idle fill character for the DTE. The modem responds to
the DTE using the same idle fill.
NOTE: This configuration option only appears if DTE Dialer is configured for V.25bis HDLC or V25bis Bisync.
The factory default is Mark.
AT command equivalent is S-register S63= n.
V.25b NewLineChr: CR+LF
Nxt CR+LF CR LF
V.25bis New Line Character. Sets the modem for the command line terminator used by the DTE in V.25bis Async mode.
The modem responds to the DTE using the same line terminator.
NOTE: This configuration option only appears if DTE Dialer is configured for V25bis Async.
The factory default is CR+LF.
AT command equivalent is S-register S64= n.
DTR Cont Repeat: Disable
End Disable Enable
DTR Continuous Repeat. Determines whether automatic redialing stops after the number in directory location 1 has been
tried unsuccessfully once. If DTR Cont Repeat is enabled, the number is redialed continuously.
A redial attempt is made in response to a bad phone number, a busy signal, no answer, or no quiet answer. However, a
lockout from redialing occurs after the number of successive failing call attempts specified in national regulations. Ten
successive attempts are permitted in North America.
NOTE: DTR Cont Repeat is accessible only if the DTE Dialer Type is DTR=Direct1.
The factory default is Disable.
Disable – Automatic redialing will not be repeated.
Enable – Automatic will be repeated if necessary.
AT command equivalent is S-register S38= n .
3821-A2-GB20-40 January 1999 3-29