Using The Timer Function; Setting The Sleep Timer - Hitachi UR 18DSAL Handling Instructions Manual

3. Press the Enter / Information button.
4. Press the Select button and display "
OFF
5. Press the Enter / Information button to complete setup.
AM broadcasts
Move the device and face it in a direction in which the
reception is best.
<Volume adjustment>
Use the Volume button to adjust the volume from 0 to 30.
USING EXTERNAL DEVICES FOR
AUDIO PLAYBACK
Audio can be played back from smartphones, portable
music players and other external devices.
CAUTION
Make sure to lower the volume output of the player
before playback.
NOTE
There are two types of connector cable, straight type and
L type.
Use an L type cable when connecting or storing large
external devices.
1. Open the external device storage area
Switch the radio's power OFF and open the front cover.
(Fig. 6)
2. Connect an external device
Using a commercially available stereo mini-plug
connector cable (ø3.5 mm), connect the radio's AUX input
port to the audio output port of the external device. (Fig. 7)
3. Secure the external device
The right and left holders can be moved to the right or left
by pinching the top and bottom of each holder.
Secure the external device between the two holders.
(Fig. 8)
4. Playback
With the radio's power switched ON, press the Source
select button and display "
AUX
Make sure to lower the volume output of the external
device before music playback.
Volume can be adjusted through the radio.
(Volume)
Close the front cover after selecting tracks and adjusting
volume.
NOTE
You may be unable to raise the volume level if the
volume level of the external device is too low.
NOTE
○ When connecting a smartphone, please be aware that
the ringtones of incoming calls for some models are not
output to speaker.
○ External devices may be damaged if used in locations
exposed to the sun or hot temperatures.
○ See page 10 when recharging with USB in "
mode.
" .
" .
"
9

USING THE TIMER FUNCTION

● Setting the sleep timer
Power can be set to automatically switch OFF after a certain
amount of time has elapsed by using the sleep timer function.
1. Press the Menu button.
2. Press the Select button and display "SLEEP".
SLEEP
3. Press the Enter / Information button.
4. Press the Select button to adjust the time period to
elapse (between "0 – 90" minutes) before the power is
switched OFF.
30 MIN
5. Press the Enter / Information button.
6. "SLEEP" will be displayed on the LCD.
○ To check the remaining time, press the Menu button
once again and select "SLEEP".
○ To cancel the sleep timer, set the time to switch OFF at 0
minutes.
● Setting the alarm (Buzzer alarm)
The radio can be set up to activate a beeping alarm at a
specifi c time.
1. Press the Menu button.
2. Press the Select button and display "BUZZER ALM".
BUZZER ALM
3. Press the Enter / Information button.
4. Press the Select button and display "
ON
5. Press the Enter / Information button.
6. Press the Select button and adjust "hour" digits.
12 : 00
7. Press the Enter / Information button.
8. Press the Select button and adjust "minute" digits.
12 : 30
9. Press the Enter / Information button.
10. Press the Select button to set up repeat.
Once
Daily
Weekdays only
Saturday and Sunday only
DAILY
English
" .
ONCE
DAILY
WEEKDAY
WEEKEND