Replacing The Seal Of The Rear Panel - Siemens INOX PRO SIMATIC IPC277D Service Manual

Extended maintenance work

4.3 Replacing the seal of the rear panel

7. Pull out the plug of the flat ribbon cable from the rear panel electronic as shown in the
figure below.
8. Place all cables whose plugs you have removed on the rear panel and the front as shown
in the figure below.
4.3 Replacing the seal of the rear panel
IP66K degree of protection
The device has IP66K degree of protection when it is closed. If the rear panel seal is not
inserted correctly or if the device is not closed properly, IP66K degree of protection is no
longer guaranteed. Humidity may penetrate the device. The result may be damage to the
device and personal injury.
Make sure you follow the instructions in this document precisely when replacing the seal.
Make sure that the seal is inserted correctly and that the rear panel is fastened properly.
Requirement
● The device is open.
● The cables between the front and the rear panel have been removed.
14
WARNING
SIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 03/2015, A5E35751762-AA