Extended maintenance work
Opening the device and working on the opened device may only be carried out by qualified
and correspondingly trained personnel
The service manual describes, amongst other points, the opening of the device and
working on the wiring or on electronic components in the inside of the device. Injuries or
material damage may result if the work is not carried out correctly.
The work described in the service manual may only be carried out by qualified specialist
personnel who have been trained correspondingly by Siemens.
After opening the device, you must replace the seal of the rear panel
The device has IP66K degree of protection when it is closed. If the seal of the rear panel is
not replaced after opening the device, the tightness of the device is not guaranteed.
Humidity may penetrate the device. This can result in personal injury or material damage.
Always replace the seal of the rear panel when you open the device. Make sure you follow
the instructions in this document precisely when replacing the seals. Make sure that the
seals are inserted correctly and that the covers are fastened properly.
Placing the device on its front can damage operator controls
If you place the device on its front before or during the installation, the operator controls on
the front can be damaged.
Place the device on a soft and elevated surface so that the front operator controls do not
contact the working area and are not damaged.
Use only approved spare parts
Installation of spare parts which are not approved for this device can damage the device,
machine or plant. The warranty becomes void if you use spare parts that are not approved.
Only use spare parts from a service pack, from a mounting kit or operator controls
according to the specification in section "Accessories and spare parts (Page 23)".
Electrostatic sensitive devices are labeled with an appropriate symbol.
SIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 03/2015, A5E35751762-AA