Table of Contents
Advertisement
VC-GA56Z
VC-GH96Z
4-3. REMOVING AND INSTALLING THE CAS-
SETTE HOUSING
• Removal
1. In the cassette removing mode, remove the cassette.
2. Unplug the power cord.
3. Remove in the following numerical order.
a) Remove two screws 1.
b) Slide and pull up the cassette housing control.
Figure 4-1.
• Reassembly
1. Before installing the cassette housing control, short-
circuit TP803 and TP802 provided at operation PWB,
press the eject button. The casecon drive gear turns
and stops when the positioning mark appears. Engage
two teeth of casecon drive gear with the three teeth of
casecon drive angle gear, and set on the mechanism
chassis as shown below.
Casecon
drive gear
Figure 4-2.
2. Install in the reverse order of removal.
Notes:
1. When fitting the S/E sensor holder to the cassette
2. Misengagement of teeth of casecon drive gear and
3. In the case when you use the magnet screw driver,
4. When installing or removing, take care so that the
1
5. After installing the cassette housing control once per-
4-4. TO RUN A TAPE WITHOUT THE CASSETTE
1. Remove the full-surface panel.
2. Short-circuit TP803 and TP802.
3. Plug in the power cord.
4. Turn off the power switch.
5. Open the lid of a cassette tape by hand.
6. Hold the lid with two pieces of vinyl tape.
7. Set the cassette tape in the mechanism chassis.
8. Stabilize the cassette tape with a weight (500g) to
9. Turn on the power switch.
10. Perform running test.
Weight to prevent
float (500g)
Note:
The weight should not be more than 500g.
Casecon drive
angle gear
To take out the cassette tape.
1. Turn off the power switch.
2. Take out the cassette tape.
12
controller frame L/R, take care.
drive angle gear causes malfunction. (The cassette
cannot be set, load and ejection are repeated).
never approach the magnet driver to the A/C head, FE
head, and drum.
cassette housing control and tool do not contact the
guide pin or drum.
form cassette loading operation.
HOUSING CONTROL ASSEMBLY
(The pole bases move into U.L.position.)
prevent floating.
500g
Figure 4-3.
Mechanism chassis
Advertisement
Table of Contents
