Delta 36-426 Instruction Manual page 13

ASSEMBLING MOTOR
AND MOTOR MOUNTING
PLATE TO SAW
WARNING: WHEN ASSEMBLING THE MOTOR
AND MOTOR MOUNTING PLATE TO THE SAW, MAKE
CERTAIN THE MACHINE IS DISCONNECTED FROM
THE POWER SOURCE.
1. Depress two pins (X) Fig. 16 and insert into holes (D)
in each side of bracket (B). Pins are spring (Y) loaded
from factory.
2. Position motor and motor mounting plate (A) Fig. 17
below bracket (B) to allow bracket arm to slide through
large opening in motor mounting plate (A).
3. Depress pins (C) Fig. 17, on both sides of bracket
(B) and rotate motor mounting plate (A) until pins (C) are
engaged in holes (D) Fig. 16, of motor mounting plate
(A).
4. Fig. 18 illustrates the motor and motor mounting
plate assembled to the rear of the saw.
B
X
D
B
C
A
13
A
X
Y
Fig. 16
C
Fig. 17
Fig. 18