Table of Contents
Advertisement
Step Six - Email Configuration
We recommend that you
create a new email account
that is dedicated to your
DVR. Three email provid-
ers are supported – Gmail
(gmail.com), Outlook (out-
look.com) and Yahoo (ya-
hoo.com). Select your pre-
ferred provider then on
your computer, go to the
relevant website to create
an account. When finished,
input those details here.
Enable Server Authentication:
User Name:
Enter the user name for the account you created.
Password:
Enter the email password for the account you created.
SMTP Server:
Gmail enter (smtp.gmail.com). Outlook enter (smtp.live.
com). Yahoo enter (smtp.mail.yahoo.com). See example above.
SMTP Port:
Gmail enter 465. Outlook enter 587. Yahoo enter 465.
Enable SSL:
Click the checkbox to enable (must be enabled).
Sender:
Enter the sender's name. See example above.
Sender's Address:
Enter the email address for the account you created.
Click the checkbox to enable.
Select Receivers:
Only one receiver is required to send alerts to, howev-
er you can send alerts to an additional two receivers.
Receiver:
Enter the receiver's name.
Receiver's Address:
Enter the receiver's email address.
Test:
Click to verify the information is correct. A message will appear
on-screen stating if the test has been successful. Click "OK" to continue.
If the test failed, try the suggestions above (top right).
Send UID:
Click this to email your DVR's UID. You can use this to access
your DVR from SwannView Plus on your mobile device or computer.
Click "OK" to complete the Setup Wizard.
Email not working, please try
the following -
1.
Check that your email and
password are correct.
2.
Located at the front of your
DVR, the network LED (NET)
should be flashing. If you don't
see this, disconnect then recon-
nect the Ethernet cable or try a
different port on your router.
3.
Search "less secure apps" at
(support.swann.com).
7
Hide quick links:
Advertisement
Table of Contents
