Honda crf250r 2012 Owner's Manual page 48

Fuel Pressure Relieving
1. Disconnect the fuel pump sub-harness
connector (1).
(1) fuel pump sub-harness connector
2. Start the engine and let it idle until the engine
stalls.
Fuel Line Replacement
Disconnection
1. Relieve the fuel pressure (this page).
2. Hang the fuel tank to the left side of the frame
(page 34).
3. Remove the fuel quick connect fitting cover
(1) from the fuel pump (2).
4. Check the fuel quick connect fitting (3) for
(1)
dirt, and clean if necessary.
Injector side:
(1) fuel quick connect fitting cover
(2) fuel pump
(3) fuel quick connect fitting
5. Remove the bolt (4), clamp and setting rubber
(5).
(4) bolt
6. Pull and release the joint rubber (6) of the
injector side from the retainer (7).
(3)
Fuel Pump side:
(1)
(6) joint rubber (injector side only)
(7) retainer
7. Place a shop towel (8) over the fuel quick
connect fitting.
Injector side:
(2)
(5)
(8) shop towel
(4)
(5) clamp and setting rubber
Fuel System
(6)
(7)
Fuel Pump side:
(8)
(cont'd)
Servicing Your Honda
41