ParaBody GS6 User Manual page 17

1/2 X 6" 3
STEP 15:
• Assemble the SEAT SUPPORT BRACKET (O) to the PIVOT ASSEMBLY (AG) and the BENCH TUBE (J) using two 1/2 X 6"
BOLTS (3) and two 1/2" LOW HEIGHT LOCK NUTS (27). (Note: Tighten this connection enough to remove excess play yet allow
the BENCH TUBE to rotate freely.)
• Assemble two SEAT HINGES (N) to the tubes on the SEAT ADJUST (M) as shown in FIGURE 15.
STEP 16:
• SECURELY assemble the BENCH SEAT PAD (AQ) to the HINGE TABS (N) using two 3/8 X 1" BOLTS (18) See FIGURE 16.
• SECURELY assemble the BENCH BACK PAD (AR) to the BENCH BRACKET (K) and the BACK TUBE (J) using two 3/8 X 3" BOLTS
(14) and two 3/8" WASHERS (23). See FIGURE 16.
J
O
J
23
3/8 X 1-1/4" 18
14 3/8 X 3"
AR
K
17
FIGURE 15
27
M
A Q
N
FIGURE 16
N