ParaBody 893104 Assembly Instructions Manual page 8

FIGURE 8
STEP 8:
• LOOSELY assemble the TOP BOOM (1) to the UPRIGHT FRAME (2) using one 1/2 X 2-1/2" BOLTS (34), one 1/2 X 3" BOLT (35),
two 1/2" WASHERS (43), and one 1/2" LOCK NUT (44) as shown in FIGURE 8.
• LOOSELY assemble the TOP BOOM (1) to the UPRIGHT FRAME (2) using one 3/8 X 2-3/4" BOLTS (32) and one 3/8" LOCK NUT
(42) as shown in FIGURE 8.
• LOOSELY assemble the TOP BOOM (1) to the UPPER CROSS SUPPORT (7) using two 3/8 X 4" BOLTS (33), four 3/8" WASHERS
(40) and two 3/8" LOCK NUTS (42). See FIGURE 8.
• Insert one 3 X 2" END CAP (19) into the end of the TOP BOOM (1). See FIGURE 8.
* SECURELY TIGHTEN ALL LOOSE CONNECTIONS MADE UP TO THIS POINT!
FIGURE 9
3/8" LOW HEIGHT 41
STEP 9:
• Slide two VINYL CAPS (27) over the LAT BAR SUPPORT (8) as shown in FIGURE 9.
• SECURELY assemble the LAT BAR SUPPORT (8) to the TOP BOOM (1) using one 3/8 X 2-3/4" (32) and one 3/8" LOW HEIGHT LOCK
NUT (41). See FIGURE 9.
1/2
0
5
19
1/2
1 2
42
42
7
40
33 3/8 X 4"
8
27
1/2 1/2
3
8
1/2 X 2-1/2" 34
1
1
32 3/8 X 2-3/4"
1/2 1/2
4 5
44
43
35 1/2 X 3"
32 3/8 X 2-3/4"
2
6