Advertisement
866101
ASSEMBLY INSTRUCTIONS
19.
Insert two 12) I/2 IN. FLANGE BEARINGS into tile BUSHING on the LEG EXTENSION a.,;
shown on
drawing.
20.
.kssemblc the LEG EXTENSION NECK to the LEG EXTENSION as shown on drawing, using one (I)
? IN. BOLT. two (2) I/2 IN. WASHERS. and one (I) 1/2 IN. LOW HEIGHT LOCK NLIT.
(TI(;HTEN
THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWING THE
EXTENSION TO ROTATE FREELY)
21.
.,\ssemble
four {4/ROLLER PADS to tile
LEG EXTENSION as shown on drawing, using two (2)
R()LLER PAD SHAFTS. and Four (4) STAR LOCK COLLARS.
,\m~ch tree (I) 3/4 IN. SO. RUBBER BUMPER to tile LEG EXTENSION approximately wh,~re silown
23.
Insert
the U-PIN (WHEN NOT IN USE) through the BUSHING of the LEG EXTENSION. and position
t behind lhc WASHER on the WEIGHT PEG of the LEG EXTENSION. (SEE DETAIL C)
>;F.CI IRELY assemble the -~RM CURL PAD to the ARM CURL FRAME as shown on drawing, usin~
m,, ~2~ ~ ,~ X I-I '4 IN. B(~I.'I'S~ m,o (2) 3/8 IN. LOCK WASHERS,
and two (2) 3/8 IN. WASHERS.
Almch two sets oFUPRI(;HT LAI~ELS (I to 12) to the inside surfaces of both UPRIGHT FRAMES
Sllown
011
drawing,;.
6
Advertisement
