ParaBody 8661O2 Assembly Instructions

Stregth building system

8661O2

STRENGTH BUILDING SYSTEM

THANK YOU

FOR PURCHASING THE 866102

STRENGTH BUILDING SYSTEM. PLEASE SAVE THESIE ASSEMBLY

INSTRUCTIONS FOR YOUR PERSONAL REFERENCE, AND ADDITIONAL SERVICE

LNFOR_MATION.

***!MP, ORTANT***

THE 866102

STRENGTH BUILDING SYSTEM MUST BE ASSEMBLED ON A FLA~, LEVEL

SURFACE TO ASSURE ITS PROPER FUNCTION.

PARABODY INC.

STRONGLY RECOMMENDS THAT THIS PRODUCT BE ASSENI]?,LED

BY TWO

PERSONS TO AVOID POSSIBLE INJURY.

IF YOU EXPERIENCE ANY PROBLEM WITH THE ASSEMBLY OF THIS PRODUCT, PLEASE

CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE REPRESENTATIVE

AT: 1-800-328-9714

TOOL-S REQUIRED:

RATCHET, 3/4

SOCKET or WRENCH, 9/16

SOCKET or WRENCH,

ADJUSTABLE WRENCH, and

RUBBER MALLET or

HAMMER

ASSEMBLY

INSTRUCTIONS

Part # 6611901

Revision: 04/30/96

Table of Contents

Need help?

Do you have a question about the 8661O2 and is the answer not in the manual?

Page 1 STRONGLY RECOMMENDS THAT THIS PRODUCT BE ASSENI]?,LED BY TWO PERSONS TO AVOID POSSIBLE INJURY. IF YOU EXPERIENCE ANY PROBLEM WITH THE ASSEMBLY OF THIS PRODUCT, PLEASE CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE REPRESENTATIVE AT: 1-800-328-9714 TOOL-S REQUIRED: RATCHET, 3/4...
Page 2 SORT AND COUNT ALL PARTS HARDWARE: ITEM NAME/DESCRIPTION 3 x 2" END CAP ... 3/8" FLAT WASHER 1/2" FLAT WASHER I/2" NYLOCK NUT ... 3/8" NYLOCK NUT ... 1/2" LOW HEIGHT NYLOCK NUT ... 3/8 X 1-1/4" BOLT 1/2 X 3" BOLT 3/8 X 2-3/4"...
Page 3 Insert one (1) 3 X 2 IN. END CAP into the top of the UPRIGHT FRAME, and two (2) 2 EN. SQ. CAPS into the BASE of the UPRIGHT FRAME as shown on drawing. Repeat this step for the second UPRIGHT FRAME.
Page 4 Assemble the BACK PAD to the WOLFF SLEEVE, slide the two (2) remaining HINGE TABS over the PIN of the WOLFF SLEEVE (ONE ON EACH Sl])E) each HINGE TAB to the BACK PAD using two (2) 3/8 X I-1/4 IN. BOLTS and two (2) 3/8 WASHERS.