Replacing The Grinding Disc (Fig. 4 - 5); Switching On / Off (Fig. 6) - Ford F181-20A Instruction Manual

The closed disc guard should always point towards the user to protect him from
sparks and chippings.
8.5 Replacing the grinding disc (Fig. 4 – 5)
Beware – a disc which has been used may be very hot!
Fig 4 :
d :two-hole spanner
Depress and hold down the spindle lock button (2) to secure the spindle.
!
Turn the shaft until it locks.
!
Remove the outer flange (a) and backing flange (b) by using the two-hole
!
spanner provided.
Fit the desired disc (8) on the spindle and replace the outer flange and backing
!
flange. Release the spindle lock.
Important! Only ever press the spindle lock when the motor
and grinding spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the
flat side facing the grinding wheel.
8.6

Switching on / off (Fig. 6)

Before engage the ON/OFF switch button, check that the
grinding disc is properly fitted and run smoothly, the outer
flange is well tightened.
Connect the battery pack onto the angle grinder body.
!
To switch on the angle grinder, push the lock-off button (9) to left or right and
!
squeeze the ON/OFF switch trigger (4)
Copyright © 2014
Original Instruction Manual
fig 5 :
a : Outer flange
b : Backing flange
c : Output spindle
P a g e
www.Ford-tools.com
| 15
EN