Table of Contents
Advertisement
WARNING: Before making any adjustments ensure the angle grinder is switched
off.
Hold the grinder with one hand and the battery pack (11) with the other.
!
To install: pull and slide battery pack into battery port, make sure the release
!
button (10) on the front side of the battery snap into place and battery is
secure before begging operation.
To remove: use your thumb or fingers, press the battery release button in and
!
pull the battery pack off at the same time.
8.3
Fitting the auxiliary handle (Fig. 1)
The auxiliary handle (6) can be attached to the angle grinder in 2 different
positions: left and right.
8.4
Assembly the protective guard (Fig. 2 – 3)
Fig 2 :
a : Shaft
Loosen the clip of the protective guard (7) by pulling lock lever of protective
!
guard (1) outward.
Turn the protective guard so that uncovered part of the disc is as far apart as
!
possible from the hand on main handle (3).
Fix the protection guard by pushing the lock lever
!
guard should no longer be able to move).
NOTE: If the protective guard can not be fixed firmly by the lock lever (1), use a
hexagon wrench to tighten the hexagon nut.
Disc guard
CAUTION! The machine should be used only with guard.
The position of the disc guard can be adjusted to suit the working conditions.
The protective guard must be replaced if damaged.
WARNING
Copyright © 2014
Original Instruction Manual
fig 3 :
a : Hexagon wrench
b : Hexagon nut
P a g e
inwards
(the protective
www.Ford-tools.com
| 14
EN
Advertisement
Table of Contents
