Table of Contents
Advertisement
Wear personal protective equipment. Depending on application, uses face
!
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or work-piece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The eye protection
must be capable of stopping flying debris generated by various operations.
The dust mask or respirator must be capable of filtrating particles generated
by your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
Keep bystanders a safe distance away from work area. Anyone entering the
!
work area must wear personal protective equipment. Fragments of work-
piece or of a broken accessory may fly away and cause injury beyond
immediate area of operation.
Hold the power tool by insulated gripping surfaces only, when performing an
!
operation where the cutting accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
Position the cord clear of the spinning accessory. If you lose control, the cord
!
may be cut or snagged and your hand or arm may be pulled into the
spinning accessory.
Never lay the power tool down until the accessory has come to a complete
!
stop. The spinning accessory may grab the surface and pull the power tool
out of your control.
Do not run the power tool while carrying it at your side. Accidental contact
!
with the spinning accessory could snag your clothing, pulling the accessory
into your body.
Regularly clean the power tool's air vents. The motor's fan will draw the dust
!
inside the housing and excessive accumulation of powdered metal may cause
electrical hazards.
Do not operate the power tool near flammable materials. Sparks could ignite
!
these materials.
Do not use accessories that require liquid coolants. Using water or other
!
liquid coolants may result in electrocution or shock.
Further safety instructions for operation
Kickback and Related Warnings
Maintain a firm grip on the power tool and position your body and arm to
!
allow you to resist kickback forces. Always use auxiliary handle, if provided,
Copyright © 2014
Original Instruction Manual
P a g e
www.Ford-tools.com
| 9
EN
Advertisement
Table of Contents
