Power On And Off / Pairing The Device - Impecca AS620BT User Manual

POWER ON/POWER OFF
Power On/Off
To switch the device on, press and hold the MF (multifunction) button for about 3 seconds and then release. The
Bluetooth blue LED turns on and slowly flashes.
Note: If the Bluetooth Wireless Speaker has already been paired or connected to another Bluetooth device before,
the Blue LED light will slowly flash as the speaker automatically attempts to reconnect to the paired device. If the
Bluetooth Wireless Speaker is unable to locate a formerly paired device within 3 minutes, or if there is no activity, it
will shut down automatically.
To turn the power off, press and hold the MF (multifunction) button for about 3 seconds and then release. The
Bluetooth blue LED light will flash and then turn off.
PAIRING WITH BLUETOOTH-ENABLED DEVICES
Pair and connect the Bluetooth Wireless Speaker with a mobile phone or other Bluetooth device
1. Ensure that your Bluetooth Wireless Speaker is turned on.
2. Press and hold the Bluetooth button for about 3 seconds. The red LED on the MF button and the blue
LED on the Bluetooth button quickly flash, indicating that the device is in 'pairing' mode.
3. Activate the Bluetooth feature on your phone or other Bluetooth devices, and set it to search for
Bluetooth devices. See the user guide of your phone for instructions.
4. Select the speaker from the list of found devices. It should show up as "AS620".
5. If your phone or device prompts you to enter a passkey or PIN-code, enter the following passcode:
0000 (four zeros) to pair and connect the headset to your phone.
Note:
If pairing is successful, the Wireless Stereo will beep when connected to your phone or other Bluetooth devices.
When the device is connected with your mobile phone and ready for use, the indicator light slowly flashes blue.
Disconnect the Wireless Speaker
To disconnect the Bluetooth Wireless Speaker from another phone or device, switch off the Wireless Speaker, or
disconnect it in the Bluetooth menu of your device. You do not need to delete pairing with the Wireless Speaker
to disconnect it.
Reconnect the Wireless Speaker
To connect the Wireless Speaker to the phone or other Bluetooth device that you have last used with it, switch
on the speaker, or make the connection in the Bluetooth menu of your device. In your phone or other device,
you may be able to allow the Wireless Speaker to connect to it automatically whenever the headset is switched
on. For further instructions, refer to the user's guide that came with your phone or device.
For some phones, you may need to make the connection separately after pairing.
You should only need to pair the device with your phone once. Check the settings on your
phone.
- 6 -