Pairing Bluetooth; Playing Music - Impecca ASB650BT User Manual

PAIRING BLUETOOTH

EN
1. As soon as you hear "The Bluetooth is ready to
ES
pair," there should be a small blue LED flashing
quickly (located under the icon). This shows
FR
that the unit is in pairing mode.
2. On your source device (phone, MP3 player,
tablet), start a "search for devices" in your
"Bluetooth" menu. The exact method varies
from device to device.
3. After a few moments, you should see a device
labeled "JQ-168A" in the list of found devices.
This is the device to connect to.
4. If your device prompts you for a connection
code, enter "0000".
5. You should hear "The Bluetooth is connected
successfully" if the connection is successful.

PLAYING MUSIC

1. If using the line-in method, use your input device
to select songs, etc. Use the volume buttons on
the top of the speaker unit to control volume.
2. If using Bluetooth
of your speaker unit to play or pause the cur-
Note: For best results, set the volume on your input device to a moderate level.
6
®
, use the buttons on the top
®
While this is happening, the blue LED should
flash even more quickly. Once complete, the
blue LED should flash at a slow and steady rate
as long as your device is connected.
6. If your device moves out of range, or Bluetooth
is turned off, the speaker will emit a polyphonic
tone and the blue LED will begin to flash rapidly.
7. Note: Once you have paired to a particular de-
vice, you should not have to pair again, unless the
device lost the settings. Upon powering on in the
future (or switching back to Bluetooth from "line-
in" mode, you will hear "The Bluetooth is ready to
pair." However, after a few seconds, you should
hear "The Bluetooth is connected successfully"
without any further intervention required.
rent song; skip or reverse your song selection,
and to change the volume of the playback. Note:
The volume control on your device will also im-
pact the volume coming out of the speaker.