Sharp XV-ZW99U Service Manual page 9

I
xv-zw99u
t @
Battery
cover
Max. distance: 23' (7 m)
Inserting the batteries
1. Press in and downward on the arrow mark (v)
and remove the battery cover.
2. Insert four AA size batteries making sure their
polarities match the + and - marks inside the
battery compartment.
3. Insert the side tabs of the battery cover into their
slots and press in the cover until properly seated.
Incorrect use of batteries may cause them to leak or burst.
Insert the batteries with the + and - polarities as indi-
cated.
Do not mix different brands of batteries. The life expec-
tancy of the new batteries will be shortened and the old
batteries may leak.
Maintain the batteries in clean condition.
Remove the batteries if the remote control will not be
used for an extended period of time.
When the batteries have been used up, remove them
immediately to prevent leakage and damage. Leaked
battery fluid may irritate the skin. Remove any battery
fluid by wiping with a cloth.
Due to storage conditions and the shelf life of the sup-
plied batteries, they may run out after a short time.
Should this occur, replace them with new batteries as
soon as possible.
Remote control positioning
The remote control can be used to control the projec-
tor in the ranges shown on the left.
. The signal from the remote control can be reflected off
the screen for easy operation. However, the effective dis-
tance of the signal may differ due to the screen material.
Using the remote control in a dark room
Press BACKLIGHT to turn on the backlights of the
operation buttons for about five seconds.
1 Side of the projector
1
-L
ml-
3.5 mm stereo
minijack cable
(sold-separately)
Using a cable with the remote control
When the remote control cannot be used due to the
range or positioning of the projector (rear projection,
etc.), connect a 3.5 mm stereo minijack cable (sold
separately) from the WIRED REMOTE CONTROL jack
on the left side of the remote control to the WIRED
REMOTE CONTROL INPUT terminal on the side of
the projector.
INoTE)
l
The signal transmitter does not operate when the cable is
connected to the remote control.