Table of Contents
Advertisement
1 1 1 1 1
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
1 . 1
1 . 1
1 . 1
1 . 1
1 . 1
GENERAL GUIDELINES
GENERAL GUIDELINES
GENERAL GUIDELINES
GENERAL GUIDELINES
GENERAL GUIDELINES
°This installation, use and maintenance guide is an integral and essential part of the product and must be kept by the user.
° Before commencing with the installation, use and maintenance of the product, carefully read all the instructions contained in this booklet.
The Manufacturer recommends carrying out all the maintenance operations described in this manual.
°This appliance must only be used as intended by the manufacturer . Any other use is considered incorrect and therefore hazardous; consequently,
the user shall be totally liable for the product if used improperly.
°Installation, maintenance and repairs must be carried out by personnel with professional qualifications and in compliance with current regulatory
standards and in accordance with the instructions of the manufacturer of the appliance.
°Use only original spare parts.
°Incorrect installation or poor maintenance could injure or damage people, animals or things; in this case the manufacturer shall be relieved of all
responsibility.
°Before commencing any cleaning or maintenance operation ensure that the appliance has been disconnected from the mains power supply by
means of the main system switch or some other disconnecting device installed upstream from the appliance.
°The product must be installed in locations suitable for fire-fighting and furnished with all the services (power and outlets) which the appliance
requires for a correct and safe operation.
°If the appliance is sold or transferred to another user ensure that the guide is handed over with it.
Thermorossi S.p.A. maintains the author's rights on these service instructions. The information in this booklet may not be reproduced or
given to third parties or used for competitive purposes without the appropriate authorization.
1.2 SAFETY GUIDELINES
1.2 SAFETY GUIDELINES
1.2 SAFETY GUIDELINES
1.2 SAFETY GUIDELINES
1.2 SAFETY GUIDELINES
PERSONAL INJURY
This safety symbol identifies important messages throughout the manual. Read the information marked by this symbol
carefully as non-observance of this message can cause serious injury to persons using the heater.
DAMAGE TO PROPERTY
This safety symbol identifies messages or instructions that are fundamental for the heater and system to function well.
To avoid serious damage to the heater adhere strictly to these instructions.
INFORMATION
This symbol indicates important instructions for good functioning of the heater. If this information is not correctly
observed, the performance of the heater and/or system will not be satisfactory.
1 . 3
1 . 3
1 . 3
1 . 3
1 . 3
S T
S T
S TAND
S T
S T
AND
AND
ANDARDS
AND
ARDS
ARDS
ARDS
ARDS
RECOMMENDATIONS
Before using the appliance, carefully read every section of this instruction manual as knowledge of the information and the
regulations contained in it are essential for a correct use of the appliance.
GENERAL WARNINGS
Caution: the appliance must be connected to a system provided with a PE conductor (in compliance with the specifications of
73/23/EEC, 93/98/EEC, concerning low voltage equipment).
Before installing the appliance check the efficiency of the earth circuit of the power supply system.
Caution
Caution
Caution
Caution
Caution: the power supply line must have a section which is suitable for the power of the equipment. The appliance must be
powered with a voltage of 220/240 V and 50 Hz. Voltage variations which exceed 10% of the nominal value can cause poor
functioning or damage the electrical device. Position the appliance so that the electric power plug is easily accessible. Voltage
variations less than 10% of the nominal value can cause lighting and use problems. Apply a current regulator.
Caution! Warning for Swiss users
Refer to the local cantonal regulations imposed by the Fire Department (Mandatory signalling and safety
distances ) and the Note concerning installation of heaters issued by the Association of Cantonal Fire Agencies
(VKF - AEAI).
1 . 4
1 . 4
1 . 4
1 . 4
1 . 4
TRANSPOR
TRANSPOR
TRANSPOR
TRANSPOR
TRANSPORT T T T T A A A A A TION
TRANSPORTATION AND HANDLING
The heater body must always be in a vertical position when handled and exclusively by means of trolleys. Take special care to protect the
electric panel, the glass, the ceramics and all the fragile parts from mechanical impact which could damage them and their correct
functioning.
STORAGE
The heater must be stored in a humid-free environment and sheltered from the weather; do not place the heater directly on the floor. The
Company denies all responsibility for damage caused to wood floors or floors made from any other material. It is inadvisable to store the
heater for long periods of time.
pg. 4
AND
AND
AND
AND
AND
RECOMMENDA A A A A TIONS
RECOMMEND
RECOMMEND
RECOMMEND
RECOMMEND
TION
TION
TION
TION
AND
AND
AND
AND
AND
STORA
ST
ST
ST
ST
ORAGE
ORA
ORA
ORA
GE
GE
TIONS
TIONS
TIONS
TIONS
GE
GE
Hide quick links:
Advertisement
Table of Contents
