THERMOROSSI ECOTHERM 1000 Installation, Use And Maintenance Manual page 17

THE GLASS IS COVERED IN
BLACK SOOT
ABSENCE OF FLOW OF
VENTILATION AIR
IT DOES NOT WARM UP
THE APPLIANCE IS OFF
BUT THERE ARE UNBURNT
PELLETS IN THE BRAZIER
PROGRAMMING AND/OR
TIME ARE NOT STORED
THE APPLIANCE ACCUMULATES PELLETS
IN THE BRAZIER
NO CAUSE
STEEL BLADE NOT PLACED CORRECTLY OR
MISSING
VENTILATION GRATE DIRTY
THE HEATER OPERATES AT INTERVALS.
THE ROOM IS TOO LARGE, THE WALLS ARE
COLD
CEILINGS TOO HIGH OR PRESENCE OF STAIRS
THAT DISPERSE THE HEAT ELSEWHERE.
THE TANK IS EMPTY
THE BUFFER BATTERY CR2032 INSIDE THE
CONTROL PANEL IS FLAT
SEE POINT "PROBLEM-CAUSE-SOLUTION"
"THE APPLIANCE ACCUMULATES
PELLETS IN THE BRAZIER WHILE
OPERATING"
CLEAN THE GLASS MORE OFTEN
PLACE THE BLADE CORRECTLY OR
INSTALL IT
CLEAN THE VENTILATION GRATE
FOLLOWING THE INSTRUCTIONS
PRESENTED IN THIS MANUAL
THE HEATER MUST OPERATE FOR MORE
HOURS WITH MORE POWER
SEPARATE THE SPACES. THE HEATER
SHOULD OPERATE FOR MORE HOURS AND
WITH MORE POWER.
SEPARATE THE SPACES. THE HEATER
SHOULD OPERATE FOR MORE HOURS AND
WITH MORE POWER.
EMPTY THE BURNER AND FILL UP THE
TANK .
REPLACE THE BATTERY (SEE PARA. 8.4)
pg. 17