Descriptions Of Controls; Description Of The Control Panel; Back Panel Of The Heater - THERMOROSSI ECOTHERM 1000 Installation, Use And Maintenance Manual

FIGURA 2
5 5 5 5 5

DESCRIPTIONS OF CONTROLS

5 . 1 5 . 1 5 . 1 5 . 1 5 . 1 DESCRIPTION OF CONTR DESCRIPTION OF CONTR DESCRIPTION OF CONTR DESCRIPTION OF CONTR DESCRIPTION OF CONTROL P

5.1.1 DESCRIPTION OF THE CONTROL PANEL

There are two main control pushbuttons marked with the ventilation symbol (2)
and the symbol of the flame (1).The flame pushbutton (1) sets the power of the
heater with 5 levels available which are activated as the 5 leds light up in
sequence (10). The off cycle is activated when all power leds are turned off. Key
(2) controls the ventilation of the heater. It is activated when the heater reaches a
temperature over 42 °C. The fan can be set to any of speed levels (9): when the
heater is on the ventilation cannot be switched off .
All controls and indicators are presented here below :
(1) Insert on/off and flame adjustment button . When you press this button the appliance (10) switches to Star / ON / OFF. Up to 5 leds (10)
are activated when pressed repeatedly.
(2) Ventilation setting button . Press this button to set the desired level of ventilation: up to a maximum of 6 speeds are available, indicated by
the lighting of the corresponding leds (9).
(3) (4) Auxiliary setting keys.
Keys (3) and (4) are operating keys necessary when on-off cycles are programmed, for operative levels, clock setting, etc..
5) Programming Enable / Disable keys.
(6) "MENU" selection button To access the main menu press the button marked with 6. Press button 6 repeatedly to scroll the adjustment,
setting and programming windows (see para. 5.2 , 5.3 , 5.4) .
(7) Display
(8) Infrared sensor for remote control
(9) Ventilation level leds .
(10) Combustion level leds

5.1.2 BACK PANEL OF THE HEATER

A description of the functions of the buttons and LEDs on the back panel of the
heater:
(11) Main switch 0-1
(12) Heater electrical power outlet 220-240V 50 Hz.
(13) Overtemperature thermostat button cap.
In the event of overtemperature this safety thermostat stops the loading of pellets.
When it is activated LED 15 comes on.
To restart the heater you need to wait until it cools down, then verify the cause for
the overheating, remove the cause, unscrew the protective cap and press the button
(13) .
(14) Feed motor test indicator light.When the pellet screw feeder is set in
motion the light must come on.
(15) Reset thermostat tripped indicator light. This LED comes on when the reset thermostat is activated.
(16) Power outlet for additional chronothermostat (see para.7) (additional chronothermostat not supplied)
(17) Power outlet for additional room temperature thermostat.(see para. 7) (additional room temperature thermostat not supplied)
OL PANEL OL P OL P OL P ANEL AND HEA ANEL ANEL ANEL AND HEATER REAR P AND HEA AND HEA AND HEA TER REAR PANEL TER REAR P TER REAR P TER REAR P ANEL ANEL ANEL ANEL
2
9
16
17
5 6
7
1
10
4 3
8
13
1 1
0
14 15
pg. 7
11
12