Installation manual Wall mounted split D4+ When installing the unit in a small room, take measures CONTENTS PAGE against to keep refrigerant concentration from exceeding allowable safety limits in the event of refrigerant leakage. PRECAUTIONS..................1 Contact the place of purchase for more information. Excessive refrigerant in a closed ambient can lead to oxygen INSTALLATION INFORMATION..............2 deficiency.
Installation manual Wall mounted split D4+ 2. INSTALLATION INFORMATION If the refrigerant leaks during installation, ventilate the area immediately. Toxic gas may be produced if the refrigerant comes into the place contacting with fire. To install properly, please read this "installation manual" at After completing the installation work, check that the first.
Installation manual Wall mounted split D4+ 3. ATTACHED FITTINGS Please check whether the following fittings are of full scope. If there are some spare fittings , please restore them carefully. NAME SHAPE QUANTITY FUNCTION 1. Owner's manual 2. Screw ST3.9x25 for installation board Secure the installation board 3.
Installation manual Wall mounted split D4+ 4. INSPECTING AND HANDLING THE UNIT 5.2 Drilling A Hole and Mounting Installation Board At delivery, the package should be checked and any damage should be reported immediately to the carrier claims agent. Installation Board and Its Direction (unit: mm) When handling the unit, take into account the following: 71\80\90 type Fragile, handle the unit with care.
Page 6
Installation manual Wall mounted split D4+ When connection extension drain hose,insulate the False installation connecting part of extension drain hose with a shield pipe mounting board of indoor unit Wall Shield pipe horizontal line Extension drainhose Drain hose Fig.5-6 Connection pipe mounting board Left piping of indoor unit...
Installation manual Wall mounted split D4+ Piping and bandaging 6.2 Material and Size of the Piping Wind the connective cable, drain hose and wiring with tape Table 6-1 securely, evenly as shown below. Pipe Material Copper Pipe for Air Conditioner Model 71/80/90 Because the condensed water from rear of the indoor unit is...
Installation manual Wall mounted split D4+ 7. WIRING CHART Model(W) 7100~9000 Phase 1-Phase Power Frequency and volt 220-240V~ 50/60Hz (All the shielding terminals of the shielding Manual switch Insurance 16/10 wires connect to the metal plate of the electric control box “ ”) Indoor unit power wiring (mm 3x2.5...
Page 9
Installation manual Wall mounted split D4+ 7.2 Capacity setting 7.1 Terminal Board Diagram Please refer to the indoor unit wiring diagram for the wiring. Horsepower code PO WER_S NOTE The air-conditioners can be connected with Central Control Monitor (CCM). Before operation, please wiring correctly and set system address and network address of indoor units.
Page 10
Installation manual Wall mounted split D4+ 7.3 Main board Code designation definition 1 means clean address reserved 0 means add. auto searching mode (default setting) 1 means DC fan Is chosen reserved 0 means AC fan Is chosen reserved reserved definition 00 means the temperature is 15 00 means the time of stopping...
Installation manual Wall mounted split D4+ 7.4 Troubleshooting ● The length of the tubing and the added stow capacity of the refrigerant have been recorded. NO. Type Contents LED Lamp flash ● Remarks The power voltage fits the rated voltage of the air conditioner. The evaporator After the malfunctions ●...
Page 12
ASK FOR MORE INFORMATION Phone: (+34) 93 446 27 80 eMail: info@mundoclima.com TECHNICAL ASSISTANCE Phone: (+34) 93 652 53 57 www.mundoclima.com...
Need help?
Do you have a question about the CL23215 and is the answer not in the manual?
Questions and answers