Filter Will Not Go Back Into Dirt Cup; Hard To Push When Vacuuming - Bissell Symphony 1132 series Troubleshooting Manual

15
Filter will not go back into the dirt cup
There is a groove on the dirt up at the top that the filter will fit into (you will see where it
says "Filter" on the dirt cup). Line up the notch on the filter with the filter groove and
push into place.
Cannot remove the dirty tank cyclone.
The dirty tank cyclone only removes from the top of the dirt cup. You will have to
remove the filters first and then pull on the red cyclone from the top. If you rinse this
out, be sure it is completely dry before putting it back into the machine.
Machine is hard to push when vacuuming
Remove the pad holder from the machine by stepping on the "foot" picture on the holder
and lift the machine off. Attempt to vacuum. The machine should push much easier on
bare floor and area rugs. To put the pad holder back on, simply line the pad holder with
the bottom of the foot and push into place. You will hear it clicks when it locks into
place.
K. Benedict 5/28/2014 C:\Users\vanwetjg\Documents\5 - Trouble Shooting
Guides\Troubleshooting 1132 Vac & Steam.doc