® SPOT POWERBRUSH HAND HELD DEEP CLEANER U S E R ’ S G U I D E 1716 Series Thanks / Consumer Services Safety Instructions Product View Features / Assembly Operation Clean-Up/Storage Troubleshooting Replacement Parts About Your Warranty...
Consumer Services department, so, should you ever have a problem, you’ll receive fast, considerate assistance. My great-grandfather invented the floor sweeper in 1876. Today, BISSELL is a global leader in the design, manufacture, and service of high quality homecare products like your BISSELL SpotLifter Thanks again, from all of us at BISSELL.
To reduce the risk of fire, electric shock or injury: Do not use for any purpose other than described in this User’s Guide. Use only BISSELL cleaning products intended for use in this appliance. Use only manufacturer’s recommended attachments. Do not expose to rain, store indoors.
Belt Cover Door Clean/Solution Tank Manual Trigger Spray Circuit Interrupting Device (C.I.D.) CAUTION: Use only BISSELL Little Green formula in your cleaner. ® Use of cleaning formulas which contain lemon or pine oil may damage this appliance and void warranty. Do not use chemical spot cleaners or solvent-based soil removers.
SpotLifter ® PowerBrush Product Features Power Switch (Black). Turns on the unit. O = “OFF” position I = “ON” position Clean/Solution Tank. Holds Little Green and water. Clean/Solution Tank Tabs. Gently press into remove the Clean/Solution Tank. Dirty/Collection Tank. Collects dirty water and solution.
How To Use Your SpotLifter Filling Your Clean/Solution Tank Remove the Clean Tank by gently pressing the Quick Release tabs on the Clean Tank and sliding the tank off of the unit. Open the tank by unscrewing and removing the cap. Add water and formula* to the indicated fill lines on the Clean Tank.
Cleaning Continued Brushing and Suction can be done separately, based on how you hold and use the unit. To Use The Dual Powerbrushes Only: Tilt the unit forward slightly, placing both brushes in con- tact with the carpet. The flat surface of the brush car- tridge should be parallel to the surface being cleaned For Suction Only: Tilt the unit forward, pressing the front of the Spotlifter...
Clean-Up/Storage Turn the power switch to the “OFF” position. ( O ) Unplug the unit. Carry the SpotLifter PowerBrush to the sink or drain. To Empty the Dirty/Collection Tank First you need to remove the Clean/Solution Tank. Gently press the Quick Release tabs on the Clean/Solution Tank and slide the tank off of the unit.
Putting It Away Store in a dry area, at room temperature to avoid freezing. To Replace the PowerBrush Belt If the belt should break, to replace: Remove the screw in the belt cover using a Phillips Screwdriver. Take the broken belt out. Replace the new belt over the 2 belt gears.
Troubleshooting Cleaner won’t run. Possible Causes Power cord not plugged in Blown fuse/tripped breaker C.I.D. needs to be reset Reduced spray or no spray. Possible Causes Spray Nozzle clogged Clean/Solution Tank empty Tank not in place properly Deep Cleaner Won’t pick up cleaning solution. Possible Cause Dirty/Collection Tank is full Dirty/Collection Tank drain plug is loose...
Replacement Parts Item Part No. Part Name 203-2501 Clean/Solution Tank w/Cap 203-2502 Clean/Solution Tank Cap Only 203-2513 Dirty/Collection Tank w/Plug 203-2504 Dirty/Collection Tank Plug Only 203-2514 Brush Cartridge 203-2517 Belt Cover 203-2516 Belt CLEANING FORMULAS 64 oz. Little Green 32 oz. Little Green 64 oz Pet Odor &...
User's Guide is not covered. If your BISSELL product should require service: Call BISSELL Consumer Services at the number below or visit the BISSELL website - www.bissell.com to locate a BISSELL Authorized Service Center in your area.