Table of Contents
Advertisement
CONTROL ASSEMBLY
Unpack the control valve assembly and inspect all components. Do
not install if damaged. Remove packaging from the appliance.
1) Open control door to access side panel retaining screws. Loosen
screws and swing right side panel open. Note the position of the
screws relative to the panel for later reassembly.
2) Install the flexible gas line connector onto valve.
3) With the controls facing forward and the pilot on the left hand side
proceed to install the valve assembly (see Fig. # 2). Feeding the pilot
through the firebox opening, ensure that the burner orifice inserts into
the end of the venturi tube. When installed properly, the valve
assembly will sit flat against the side of the firebox.
4) Fasten in place with six #8 x 1/2" sheet metal screws provided; two
screws at the top, two in the middle and two at the bottom of the control
assembly.
5) Connect burner switch wires to the back of the rocker switch.
6) Insert valve knob extensions through the control panel and onto
their corresponding valve knobs.
f i r e - p a r t s . c o m
Fig. # 2
Venturi Tube
Burner Orifice
4
7) Install optional blower kit, if it is to be installed. See "OPTIONAL
BLOWER" section for details.
Caution: Before making wiring connections, ensure all electrical
power is disconnected!
8) The gas connection may now be made. See "GAS SUPPLY"
section for details.
9) Place the self-adhesive label on the rating label into the blank box
provided to designate the type of gas the appliance is connected to.
The rating plate is located on the left side of the pedestal base.
After all gas connections are checked and operation of the unit is
verified, the side panel may be closed. Line up the slots in the control
panel with screws in front edge of the side panel. Adjust the side panel
so that the control door closes properly and the panel is even with the
top panel and pedestal side.
Pilot
Hide quick links:
Advertisement
Table of Contents
