JVC UX-H10 Service Manual page 9

3.1.4 Removing the CD mechanism board
(See Fig.11 ~ 13)
• Prior to performing the following procedure, remove the front
panel assembly, the main board and the CD mechanism
assembly.
(1) Disconnect connector on the CD mechanism.
(2) Remove the four screws H on the CD mechanism
assembly.
(3) Cut off the band setting each wire and disconnect the card
wire from connector on the CD mechanism.
(4) Remove the screw J attaching the wire on the CD
mechanism board.
Caution:
The metal washer and nut come off.
(5) Remove the four screws K attaching the CD mechanism.
CD mechanism
board
H
Band
Fig.11
CD mechanism
board
Connecter
J
Nut
CD mechanism
Fig.12
CD mechanism
assembly
K
Fig.13
Front panel
Switch board
H
Connecter
CD mechanism
assembly
Band
assembly
CD mechanism
K
(No.MB066)1-9