JVC UX-H10 Service Manual page 11

3.1.8 Removing the Transformer board
(See Fig.17)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the screw Q on the rear cover assembly.
(2) Pull out the transformer board in the direction of the arrow.
(3) Unsolder the wire extending from the transformer.
3.1.9 Removing the Transformer
(See Fig.18 , 19)
• Prior to performing the following procedure, remove the front
panel assembly and the transformer board.
(1) Remove the two screws R attaching the voltage selector on
the bottom of the rear cover assembly.
(2) Remove the four screws S on the rear cover assembly.
(3) Remove the two screws T setting the power cord on the
rear cover assembly.
(4) Cut off the band connecting the power cord to the
transformer if necessary, remove the transformer.
3.1.10 Removing the FM-antenna board
(See Fig.19)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the screw U on the rear cover assembly.
(2) Unsolder the FM-antenna wire on the FM-antenna board.
Q
Fig.17
Fig.18
Solder point
FM ANT board
U
T
Fig.19
Trans borad
Solder point
R
e Section
S
S
(No.MB066)1-11