Crown Punch Cleaning - EDLUND 610 Operating Instructions Manual

Crown Punch Cleaning

BEFORE PERFORMING ANY MAINTENANCE, YOU MUST DISCONNECT THE OPENER FROM THE AIR
SUPPLY.
Remove the splash guard, crown punch, guard ring, and retainer clip (Figure 3 on page 8) after every use for
cleaning. You may rinse down the entire machine with soap and water to remove any residue from the unit.
USE CAUTION HANDLING THE CROWN PUNCH IN THE NEXT STEP.
1. Remove the tooling per
2. Wash down and sanitize the entire splash zone area and any other areas of the machine that may have
food contamination on it. Foreign material that remains on the machine will dry and create unsanitary
conditions and can affect the performance of the machine. Failure to do so can result in valve and
cylinder damage causing costly repairs.
3. Reassemble the crown punch, guard ring, retainer clip, and the splash guard.
4. Be sure all screws are tight.
5. Reconnect the air supply.
TIP: Cover the air inlet to insure water does not enter the crown punch machine when sanitizing.
Edlund Company CROWN PUNCH CAN OPENER, Models 610M and 610
10
Changing Tooling
on page 9.