Reassembling The Final Case - Mitsubishi MT160 Repair Manual

's
11
t.
11
;)
11'
:1'
:e
Ig
~e
is
m
ld
Ip
is
Id
~r
;h
;h
:d
er
and increase or decrease the thickness of
the liner there.
(c) A proper backlash having been secured,
measure the clearance between the right-
side holder and case, and fill the clear-
ance wi th another liner equal in thickness
to the reading. This liner, too, is to be
formed in the same way as above. Put on
stopper washers and tighten the right-
side holder.
(d) Tap lightly on the differential gear case
in place, directing the tapping force
leftward and rightward to be sure that
this case has no end play. Re-check the
backlash and, upon noting that it is
within the specified range, lock the bolts
securing the bearing holders, right and
left, by bending stopper washers sharply.
The holder bolts are to be tightened to
this torque value:
Tightening torque
2.5
~
3.0 kg-m
(18 ~ 22 ft-lb)
TRANSMISSION SYSTEM
Reassembling the final case
Circlip
Ball bearing
Circlips
(I)
Grease oil seals, and fit the seals to those
parts of final case admitting differential
shaft and final shaft. For the final shaft,
however, a washer must be installed before
fitting the oil seal.
(2) Press ball bearing onto differential shaft.
Grease "0" ring and fit it to oil seal collar.
Feed the collar onto differential shaft, with
its "0" ring coming next to the ball
bearing.
(3)
Insert differential shaft into final case, and
set it in place by fitting circlip.
(4)
Position final shaft in final case, fit ball
bearing by pressing, and retain the bearing
by installing circlip.
[NOTE]
When forcing the bearing in, be sure
to apply the push to its inner race.
5-21