Inspection And Maintenance - Mitsubishi MT160 Repair Manual

CLUTCH SYSTEM
INSPECTION
Inspection Maintenance Service limit
Contact of clutch disc with Smooth out if within the service limit. If the distance between rivet head and
matching parts, seizure, and If exceed service limit, replace.
facing is 0.3 mm (0.012 in.) or less,
cracks replace.
Oily or greasy clutch disc Eliminate the cause. If oil or grease is If oil or grease is too much, replace.
little, wipe it off with cloth damped with
gasoline and allow it to dry.
Hardened surface of clutch Smooth out hardened surface. If the distance between rivet top and
disc facing is 0.3 mm (0.012 in.) or less,
Wear on clutch disc Measure gap between rivet top and facing.
replace.
Deflection of clutch disc Rotate the clutch disc, and measure If deflects 1 mm (0.03 in.) or more,
deflection at its outer edge. replace.
Loose rivet Replace, even if facing thickness is within
the allowable limit.
Scratches or burning on
Smooth out. Readjust clutch pedal free
25
~ 30 mm (1 ~
1-3/16 in.)
pressure plate play properly.
Flatness of pressure plate If impossible to correct by smoothing out
the surface, replace.
Release bearing Washing is not allowed. Rotate it by hand. If abnormal noise is
heard, or it turns irregularly, replace.
3-10