Replacing Lamp; Maintenance Of Sewing Machine - Singer XL-6000 Instruction Manual

Replacing lamp

1
Open face plate cover.
Face plate
cover
Draw out lamp until it
4
comes off.
Lamp
Draw lamp out without twisting it.

Maintenance of sewing machine

Cleaning to remove lint and dust.
125
Caution
*Be sure to turn off power switch and detach plug from wall outlet before
replacing a lamp bulb.
*Be sure to replace lamp after it has cooled.
2
Remove lamp mounting base.
Lamp mounting
base
Setscrew
Loosen setscrew and remove
lamp mounting base.
5
Fit a new lamp in place.
Slide lamp into place along narrow
groove on lamp base.
Caution
Be sure to turn off power switch and detach plug from wall outlet
before performing maintenance of your machine.
Accumulation of lint or dust may cause problems. Always keep your sewing
machine clean.
Remove needle and presser foot, and clean areas around feed dog, throat
plate and rotating hook bobbin case holder using brush supplied with your
machine as an accessory.
If lint or dust accumulated is too much to clear with brush, remove it with a
vacuum cleaner.
Remove lamp base from lamp
3
mounting base.
Lamp base
Lamp mounting
base
* When installing lamp base, align
groove on lamp base with that on
mounting base.
* Power consumption of lamp: 3 W (13.5 V)
* Please purchase a new lamp from service center or
from Singer Dealer where you purchased your
machine.