Specification Table - Singer XL-6000 Instruction Manual

Problem

Specification table

Standard sewing machine
Item
Dimensions 479 (W) x 324 (H) x 215 (D) mm
Dimensions when
495 (W) x 330 (H) x 235 (D) mm
attached with case
12.4 kg (when attached with case: 13.7 kg)
Weight
Rated
120/0.9A
voltage/power con-
sumption
Power consump-
13.5V / 3W
tion of lamp
Sewing machine will not sew
when start/stop button is
pressed.
Thread breaks.
Stitch skips.
Thread tension cannot be
properly regulated.
Seam puckering occurs.
Sewing machine fails to auto-
matically wind a bobbin.
Specification
60 Hz
Cause (Reason)
Speed controller has been
plugged in.
Sewing machine is incorrectly
threaded.
Thread used has kinks or
knots.
Thread tension is not properly
adjusted.
Needle is bent or has blunt tip.
Needle is incorrectly attached.
Rotating hook bobbin case
holder is incorrectly threaded.
Bobbin fails to smoothly rotate
in rotating hook bobbin case
holder.
Needle does not match thick-
ness of thread used.
Thread take-up lever is not
threaded.
Thread detecting thread guide
is not threaded.
Sewing machine head is not
properly threaded.
Bobbin thread is not properly
routed.
Orientation of thread spool
cap does not match that of
thread spool.
Stitch length is too large to
sew light-weight fabric.
Needle has blunt tip.
Main body of sewing machine
is not properly threaded.
Retaining plate is not properly
thread with (embroidery)
thread
Parts related to bobbin
winding is tangled with thread
waste or thread.
Embroidery Unit
Item
Dimensions
Dimensions when
installed on sewing
machine
Weight
Action to be taken
Unplug speed controller.
Check threading sequence
and re-thread machine head
correctly.
Remove kinks or knots from
thread.
Check relation between stitch
pattern selected and sewing
thread used. Then, properly
adjust thread tension.
Replace needle with a normal
one.
Correctly attach needle.
Check threading route of
bobbin thread.
Check how bobbin thread is
wound round bobbin.
Check relation between
sewing thread and needle.
Check threading route of
needle thread.
Securely thread thread de-
tecting thread guide so that
thread passes deepest part of
guide.
Check how machine head is
threaded.
Check threading route of
bobbin thread.
Attach thread spool cap in
correct orientation with
respect to thread spool.
Decrease (shorten) stitch
length.
Replace needle with a normal
one.
Check threading sequence of
machine head and re-thread it
properly.
Open thread retaining cover
to check that retaining plate is
properly threaded. Re-thread
retaining plate using bobbin
winder guide.
Remove thread waste or
thread using a pair of
tweezers.
Specification
33.5 (W) x 13.0 (H) x 32.0 (D) cm
59.5 (W) x 32.4 (H) x 33.5 (D) cm
2.3 kg (when installed on sewing
machine: 13.0 kg)
Page
9
11,12
_
22
27
27
120
_
27
11,12,
121
11,12,
121
11,12,
121
120
11,12
20
27
13,14
66
_
124