Fan Sled Disassembly - Carrier 39LH Installation, Start-Up And Service Instructions Manual

Fan Sled Disassembly —
units (39LD, 39 LF, or 39LH), it may be necessary to remove
the fan sled (Fig. 55) from the unit and break it down into
smaller components.
Fig. 55 — Fan Sled
To remove the fan sled:
1. Disconnect the fan discharge by removing the screws
from the discharge of the fan housing. Remove the fan
discharge panel (Fig. 56).
2. Remove all of the panels from the fan section (Fig. 57).
3. Remove the fan by removing the 4 screws on the corner
of the fan sled. On larger units the fan sled may be ex-
tremely heavy. Affix appropriate rigging to remove the
required components, noting on a diagram where each
component is attached. See Fig. 58.
NOTE: Reinstall the components in reverse order.
Fig. 56 — Remove Fan Discharge Panel
in some cases on vertical
a39-4456
a39-4457
Fig. 57 — Remove All Panels
Fig. 58 — Remove Fan
46
a39-4458
a39-4459