Menu Control; Navigation In The Menus - Grundfos Conex DIS-C Installation And Operating Instructions Manual

12.2 Menu control

Main menu
Temp. compens.
Temp. compens.
Manual temp.
Enter password Enter password
Setpoint S1
Prop. and xp S1
Reset time TN S1 000 s
Controller
Setpoint S2
Prop. band xp S2 10 %
Reset time TN S2 000 s
Alarm value A1
Alarm values Alarm value A2
Delay
Setup See table below
Service See table below
Setup menu
Corr. temp. Corr. temp.
Pulse freq. S1
Pulse freq. S2
Ctrl. direction S1 Downward control
Contr. param. Ctrl. direction S2 Upward control
Hysteresis
Int. pulse period 10 s
Min. switch-on
Delay ctrl.
Delay ctrl.
Delay ctrl.
Select output
Start 0/4 mA
Analog output
End 20 mA
Analog output
Language Sel. language
Temper. coeff. Temper. coeff.
Cell const. Cell const.
Cable
Cable compens. 00.0 μS
compens.
Measur. range Measur. range
Averaging Averaging
20
Service menu
Default values
Manual comp. Product info
025 °C
Code 086
Analog input
02.5 μS
10 % Delete setting

12.3 Navigation in the menus

02.0 μS
•
•
00.0 μS
02.0 μS
•
•
0.05 s
Default values
0 °C
0-180 / min
0-180 / min
00.1 μS
0.5 s
off
180 s
0-20 mA
00.0 μS
200.0 μS
Measured value
Deutsch
0.0 % / °C
0.050
20.00 μS
off
Unit No.
Software date
Product. date
Input 1
Input 2
Delete setting
To navigate in and between menus, use the [Up]
and [Down] buttons.
Use the [Right] button to open the menu next to
it. The currently active menu control buttons are
displayed in the corresponding line.
Use the [Left] button to save values.
Use [OK] to exit the menu and return to the start
display.
Important menu selections and changes to
Note
data are code-protected to prevent
unauthorised access.
The order of the settings in the following
section is different to the order of menu
Note
navigation. This section describes the
basic settings that are made first during
setup.
Default values
No. 041
M/Y 1.00
M/Y 1.00
-019
000 °C